Get the PDF.
Brick
| << < Previous | Step: 8 of 9 | Next > | |
|
Encompassing Doors
Start by fastening Trim Channels along the outside edge of the door. Next, if your Moderra Brick wall is going to extend above the door, attach a Starter Ledge or angle iron at the top. You must also decide if you will flash or caulk the unit by the Trim Channel.
Apply a thin layer of Super-Stik to the Trim Channel and slide the cut units into the corresponding Moderra Bracket. Alternatively, you can use a Moderra Tie. Now that your door is prepared, cut or split your Moderra Brick units to the length needed. Continue up the wall until past the door. Once past, place the Moderra Brick onto the Starter Ledge and continue as you would with a normal row. Proceed up the opposite side of the door in the same way you did the first side. Cut or split the Moderra Brick units so they will continue to maintain a consistent pattern. Finally, place flashing or caulking between the door and the Moderra Brick units to prevent moisture from falling behind the wall. |
    |